Help: Moving a projectile through a pipe

July 9, 2003, 18:31

Hello everyone. I have questions about using Fluent 6.1 for calculation of moving a projectile through a pipe.

What from deforming mesh possibilities of the version of Fluent is better for the problem: sliding mesh model or dynamic meshes?

Are there any special tutorials describing of using Fluent for such problems?

Any help would be appreciated. Regards

Valery

July 10, 2003, 02:32

Hi use dynamic mesh (layering) for the same problem type.

July 9, 2003, 18:31	Help: Moving a projectile through a pipe	#1
Valery Ponyavin Guest Posts: n/a	Hello everyone. I have questions about using Fluent 6.1 for calculation of moving a projectile through a pipe. What from deforming mesh possibilities of the version of Fluent is better for the problem: sliding mesh model or dynamic meshes? Are there any special tutorials describing of using Fluent for such problems? Any help would be appreciated. Regards Valery

July 10, 2003, 02:32	Re: Help: Moving a projectile through a pipe	#2
alexandre Guest Posts: n/a	Hi use dynamic mesh (layering) for the same problem type.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[DesignModeler] DesignModeler Pipe within pipe	shields	ANSYS Meshing & Geometry	13	November 25, 2018 22:14
Help needed in modelling/meshing a body moving in a pipe which is driven by a fluid	hareshram.n	ANSYS	0	March 19, 2010 02:23
Moving pipe	Raúl Bermejo	FLUENT	0	September 28, 2005 06:35
Terrible Mistake In Fluid Dynamics History	Abhi	Main CFD Forum	12	July 8, 2002 09:11
fluid flow fundas	ram	Main CFD Forum	5	June 17, 2000 21:31