|
[Sponsors] |
August 7, 2003, 07:43 |
Boundary conditions for window openings
|
#1 |
Guest
Posts: n/a
|
Hi, I want to simulate the airflow for window openings under different outside wind speeds. So I divided the simulation space into two parts, one is the outside zone (for outside wind flow), and the other is the interior zone (for the air flow inside the room), and set the windows in two directions. As it is difficult to know the flow direction at these two openings, their boundary types are assumed to be pressure-outlet. But the Fluent told me the openings have two adjacent cell zones, and the grid check was failed. Could anyone give me some advice on setting the boundary conditions for openings, which connect the interior zone and the outside zone. Thanks very much.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Boundary conditions for 2D Navie-Stockes simulation | L1011 | OpenFOAM | 5 | December 13, 2012 08:17 |
[Netgen] boundary conditions and mesh exporting | vaina74 | OpenFOAM Meshing & Mesh Conversion | 2 | May 27, 2010 09:38 |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Please help with flow around car modelling! | Tudor Miron | CFX | 17 | March 19, 2004 19:23 |