|
[Sponsors] |
October 2, 2003, 09:59 |
Help with 3D Two Phase Flow
|
#1 |
Guest
Posts: n/a
|
I am currently working on an aerofoil partially submerged in water with air as the second phase. I have set the fluids to be imiscible with separate velocities. This should create a free surface with a wave over the aerofoil. However it is not solving. I am using Fluent 6, does anyone have any suggestions as to where my model could be going wrong.
Any help would be much appreciated. |
|
October 7, 2003, 08:06 |
Re: Help with 3D Two Phase Flow
|
#2 |
Guest
Posts: n/a
|
Hi!
I've seen some simmilar simulations using VoF...maybe that's your answer. Regards MATEUS |
|
October 29, 2003, 13:29 |
Re: Help with 3D Two Phase Flow
|
#3 |
Guest
Posts: n/a
|
Make sure that you are specifying your volume fractions correctly, i.e. vof1 and vof2.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
gas-liquid 2 phase flow in microchannels using VoF | LyngHoo | FLUENT | 1 | November 13, 2012 19:01 |
Two Phase Darcy flow with gravity -> problem | Cyp | OpenFOAM Programming & Development | 0 | November 17, 2010 07:58 |
two phase flow + ice phase and breaking | soeren87 | OpenFOAM Running, Solving & CFD | 0 | September 19, 2010 10:20 |
Validation for laminar Disperse phase flow | shashwat | Main CFD Forum | 0 | April 4, 2008 02:20 |
how 2 freeze 1 phase flow field & start lagrangian | KK | CFX | 5 | February 14, 2008 16:48 |