|
[Sponsors] |
December 10, 2003, 09:36 |
3d transition patterns
|
#1 |
Guest
Posts: n/a
|
Is it possiable to specify a boundary layer mesh transition pattern apart from 1:1 on a face of an internal 3d block. When I set the face boundary layer mesh of the face on the block the attachent changes from face to edge when the trasition pattern is changed from 1:1 to any others (4:2, 3:1, 5:1). When I mesh with this boundary layer mesh inside the block I recieve an error with hex submap, hex tri-primative and tet/hybrid. Any help?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transition Models Help | paulnardone | STAR-CCM+ | 2 | September 22, 2011 19:16 |
Missing Information in SST Transition Model Formulation | Josh | CFX | 2 | September 14, 2010 11:49 |
Code release: Flow Transition and Turbulence | Chaoqun Liu | Main CFD Forum | 0 | September 26, 2008 17:15 |
to LANGTRY ROBIN :help, hypersonic transition SST | ben akih | CFX | 0 | September 21, 2006 04:59 |
modelling transition with v2f turbulence model | pablo | FLUENT | 0 | August 7, 2006 15:44 |