Home > Forums > Software User Forums > ANSYS > FLUENT

3d transition patterns

Mark Forums Read

Reply

Search this Thread

December 10, 2003, 10:36	3d transition patterns	#1
Andrew Garrard Guest Posts: n/a	Is it possiable to specify a boundary layer mesh transition pattern apart from 1:1 on a face of an internal 3d block. When I set the face boundary layer mesh of the face on the block the attachent changes from face to edge when the trasition pattern is changed from 1:1 to any others (4:2, 3:1, 5:1). When I mesh with this boundary layer mesh inside the block I recieve an error with hex submap, hex tri-primative and tet/hybrid. Any help?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Transition Models Help	paulnardone	STAR-CCM+	2	September 22, 2011 20:16
Missing Information in SST Transition Model Formulation	Josh	CFX	2	September 14, 2010 12:49
Code release: Flow Transition and Turbulence	Chaoqun Liu	Main CFD Forum	0	September 26, 2008 18:15
to LANGTRY ROBIN :help, hypersonic transition SST	ben akih	CFX	0	September 21, 2006 05:59
modelling transition with v2f turbulence model	pablo	FLUENT	0	August 7, 2006 16:44

All times are GMT -4. The time now is 01:09.