 |
 |
 |
|
|
|
[Sponsors] | ||||
December 29, 2020, 00:55
|
Parallel Processing
|
#1 |
|
New Member
Suryawanshi Vijaykumar Madhukarrao
Join Date: Dec 2020
Posts: 1
Rep Power: 0  |
Hey there,
I am simulating a continuous air jet at 50 mps on a heated plate. For that in setup I choose parallel processing and no. of processors 8 and GPU 1 as my laptop have 8 logical processors and 1 GPU. But when hit the calculate button after sometime setup is automatically closing and showing right green tick. What's the causing this? (And one more thing in console when I opened setup out of 8 processors only one is showing " *" mark.) |
|
|
|
|
 |
| Tags |
| air jet, ansys fluent 19.2, heat transfer, parallel processing |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Doubt about parallel processing | vishwesh | OpenFOAM Programming & Development | 0 | November 10, 2017 06:20 |
| Parallel processing of OpenFOAM cases on multicore processor??? | g.akbari | OpenFOAM Running, Solving & CFD | 31 | November 1, 2017 09:25 |
| foamMonitor in parallel processing | foamingMouth | OpenFOAM Running, Solving & CFD | 0 | September 15, 2016 09:44 |
| Grid Check Fails in Parallel Processing Mode | askance | Main CFD Forum | 0 | October 20, 2010 10:11 |
| Question about ghost cells in parallel processing | vishwas | Main CFD Forum | 3 | March 12, 2006 21:46 |
Linear Mode
