|
[Sponsors] |
January 10, 2005, 17:59 |
2D cylinder modelling
|
#1 |
Guest
Posts: n/a
|
Hi
I am using fluent 6.0 to study the flow over a cylinder as a part of a bigger study involving more complex shapes, as vehicles. My problem is DRAG. Watching the graph on the evolution of drag with Re, you can see a plateau of about 1.0 from 1e3 to 1e5. then goes down to about 0.35 at 5E5 or 1E6. Ok, nothing new until now. I tried a k-e raelizable model with enhanced wall treatment. The constants used where both the default ones and the poroseva ones for airfoils. I get ok the low Cd, but the high ones below 5E5, there is no way to obtain them Is there some obvious mistake which I havenīt gone through? Have some of you tried modelling a 2D cylinder? If so, which viscous modells have you used and with what constants? Thanks for your help: Miguel UPM Madrid |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2D modelling of flow past a rotating cylinder | pds24 | Main CFD Forum | 1 | August 21, 2015 11:50 |
Modelling a cylinder in a tank | egge24 | FLUENT | 5 | September 10, 2011 19:39 |
Modelling cylinder in CFX | Ken | CFX | 6 | February 12, 2008 22:02 |
PLEASE HELP HELP modelling free vibration cylinder | Ken | FLUENT | 0 | June 23, 2007 12:35 |
modelling cylinder | Sham | FLUENT | 0 | March 19, 2007 21:15 |