|
[Sponsors] |
March 19, 2005, 06:00 |
Boundary Layer Necessary???
|
#1 |
Guest
Posts: n/a
|
hi,
I have been making a 3D flow analysis. Although my geometry is not very complex, I couldn't form a boundary layer on the faces of the geometry. Also the analsys results are slightly below the real results, drag ceoffiient should be 0.6 but Fluent calculates it like 0.43. I wonder could this difference caused by the lack of boundary layer in my mesh? Thanks, Taskin |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Default Faces on Boundary Layer | axel | OpenFOAM Meshing & Mesh Conversion | 8 | February 17, 2011 07:47 |
Boundary Layer Question | scottneh | STAR-CCM+ | 3 | September 30, 2010 14:21 |
Adapt mesh without modifying boundary layer cells? | Freeman | FLUENT | 0 | February 22, 2009 14:11 |
3D Boundary Layer | Mario | FLUENT | 0 | February 17, 2009 03:40 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |