|
[Sponsors] |
April 12, 2005, 07:13 |
aeroacoustics in fluent
|
#1 |
Guest
Posts: n/a
|
I am experencing a problem in loading the "acoustics" module of the fluent. After finishing the LES calculation (reaching to the steady state)and setting the parameters (needed for noise calculation-at acoustics panel(s)), the "EXECUTE ON DEMAND" command does not go through, as the "access voilation" error appears on consol window. so, please any recommendation or instruction to resolve this problem?
thanks |
|
April 12, 2005, 12:10 |
Re: aeroacoustics in fluent
|
#2 |
Guest
Posts: n/a
|
Check of the university has license for the acoustics module.
-H |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stopping a Fluent batch job AND saving the data! Possible? | Volker Pawlik | FLUENT | 13 | December 28, 2020 04:16 |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
Fluent 6.3 32bit vs Fluent 12.0 64bit | ibex7 | FLUENT | 7 | April 18, 2011 02:44 |
Compared MRFSimpleFoam and Fluent in a centrifugal pump! | renyun0511 | OpenFOAM Running, Solving & CFD | 8 | July 6, 2010 06:24 |
Fluent 12.0 is worst then Fluent 6.2 | herntan | FLUENT | 5 | December 14, 2009 02:57 |