|
[Sponsors] |
set boundary condition in Neutral file, in Gambit |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 25, 2005, 23:40 |
set boundary condition in Neutral file, in Gambit
|
#1 |
Guest
Posts: n/a
|
In Gambit, when setting "Solver->Generic" so as to export Neutral file, there are only two boundary condition types, ELEMENT SIDE & NODE. Anybody know how to introduce other BC types, such as , wall/mass flow inlet when exporting Neu file? (not *.msh). Any help will be appreciated!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
[OpenFOAM] Paraview command not found | hardy | ParaView | 7 | September 18, 2008 04:59 |
Compiling OpenFOAM13 on AMD64 with Redhat Enterprise | mbeaudoin | OpenFOAM Installation | 20 | June 17, 2008 06:43 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
PHI file structure | Eugene | Phoenics | 9 | November 2, 2001 22:00 |