 |
 |
 |
|
|
|
[Sponsors] | ||||
May 20, 2005, 15:41
|
creating plane with text menus
|
#1 |
|
Guest
Posts: n/a
|
When I open the GUI Plane Surface interface I can create a plane by simply inputting coordinates for 3 points. The plane is the entire size of my domain. I would like to do this using the text menus but cannot figure out how. Does anyone know?
The bounded plane does not give me what I want, though I could probably manipulate it to do so with a fair amount of effort. None of the other options are quite right either. I just want to give fluent 3 points and have it make the plane, just like it does with the GUI. Thanks, Jenifer |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
| [Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
| Help with creating a plane in the domain | Tony | CFX | 2 | September 14, 2004 18:12 |
| Creating an eliptical plane | Karthick | FLUENT | 0 | August 13, 2004 05:37 |
| Creating plane | soody | FLUENT | 2 | April 21, 2004 06:43 |
Linear Mode
