|
[Sponsors] |
May 25, 2005, 07:59 |
3D swirler modelling
|
#1 |
Guest
Posts: n/a
|
hi all, I have a bit of a problem with 3D swirler modelling. I have actually done most of it in gambit, then tried to apply the BCs. But the problem is that Fluent isnt recognising the side-tip of the swirler blades.....it is skipping them.
SO i tried to specify the total swirler volume as a solid-continuum, but it isnt shown at all in the display-in Fluent. someone help me please....I am all eagerly waitin for ur replies ! thanx, sarat. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Modelling unsteady 2D aerofoil drag | xlxc34 | Main CFD Forum | 0 | June 24, 2011 04:42 |
Advice on multi-phase flow modelling | Martin | Main CFD Forum | 3 | October 14, 2008 05:16 |
Unsteady modelling technique? | Carlos | FLUENT | 0 | September 26, 2008 11:37 |
how to ensure that your modelling is correct | rvndr | Main CFD Forum | 7 | March 1, 2004 12:21 |
Computational Modelling of Vortex Separators | May Lim | Main CFD Forum | 6 | November 13, 1998 12:36 |