|
[Sponsors] |
August 9, 2005, 06:43 |
combustion
|
#1 |
Guest
Posts: n/a
|
iam doing laminar non premixed combustion. i have done the cold flow simulation.can any one tell how to proceed to combustion modeling .
bye |
|
August 9, 2005, 11:07 |
Re: combustion
|
#2 |
Guest
Posts: n/a
|
I guess you set-up a complete model and included all specific requirements of the flamelet model including reaction. then,you turned them OFF and ran your simulation. this gave you a converged flow field. if this is what you did, then further things are: save the results of cold flow simulation in .dat file. turn ON all your reaction inputs and energy inputs. read the newly saved data file to start with the already known flow pattern and start the simulation. your source terms and energy equation will couple with the other equations.
Regards, Swarup. |
|
August 9, 2005, 11:09 |
Re: combustion
|
#3 |
Guest
Posts: n/a
|
thank u
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Modelling Combustion in Porous Zone | tanjinjack | FLUENT | 2 | September 26, 2016 04:10 |
hydrocarbon gases + Boron particle combustion | nileshjrane | OpenFOAM | 1 | December 13, 2010 06:20 |
Hydrogen Air combustion in a combustion chamber | popi | CFX | 7 | July 11, 2007 18:40 |
Need Similar Combustion Tutorial as my model | Arnab | Siemens | 0 | May 24, 2005 18:23 |
Multiresolution + Turbulence + Combustion | Raul | Main CFD Forum | 0 | March 18, 2005 07:53 |