 |
 |
 |
|
|
|
[Sponsors] | ||||
September 17, 2005, 09:04
|
2 velocities in VOF
|
#1 |
|
Guest
Posts: n/a
|
I am simulating a thin liquid film on a pipe wall which travels at a much lower velocity than the gas phase. The liquid film moves at a velocity of about 0.1 m/s. The gas phase moves at a velocity of 6 m/s. Is this possible when using the VOF model? Also, the liquid volume fraction is about 6% at the pipe inlet.
Thank you. |
|
|
||
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| VOF Inlet condition | Rizwan | FLUENT | 15 | July 5, 2018 16:33 |
| ATTENTION!! Validty of Fluent's VOF?? | ozgur | Main CFD Forum | 3 | February 18, 2004 18:19 |
| ATTENTION!! Validty of Fluent's VOF?? | ozgur | FLUENT | 1 | February 18, 2004 11:59 |
| Difficult BCs about Freesurface Simulation by VOF | Yongguang Cheng | FLUENT | 0 | September 19, 2003 07:39 |
| about VOF model | rey | FLUENT | 5 | August 13, 2002 06:02 |
Threaded Mode
