|
[Sponsors] |
Meshing divergent nozzle entry of a long pipe |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 22, 2005, 13:06 |
Meshing divergent nozzle entry of a long pipe
|
#1 |
Guest
Posts: n/a
|
I am trying to mesh a geomtery with structured mesh however i am unable to mesh it.
the geometry is a divergent nozzle entry into a long pipe. the divergent entrance also have a smaller pipe attached from above just 100mm before outlet for air entrance. divergent nozzle (inlet D=150mm and outlet D= 254mm, length = 470mm) long pipe (dia=254mm, length=36000mm) smaller pipe (D= 50.8mm, length = 250mm) any advice on how to mesh this geomtery will be highly appreciated. |
|
September 25, 2005, 18:07 |
Re: Meshing divergent nozzle entry of a long pipe
|
#2 |
Guest
Posts: n/a
|
subdivide your domain
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Meshing a pipe with a hole | leekj92 | ANSYS Meshing & Geometry | 8 | May 19, 2011 14:34 |
Long pipe | Derek | CFX | 11 | April 2, 2007 19:18 |
CFX-mesh for a long pipe | Julian | CFX | 4 | September 27, 2005 05:19 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 10:11 |
fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 22:31 |