|
[Sponsors] |
November 10, 2005, 10:59 |
risidual at high level
|
#1 |
Guest
Posts: n/a
|
Hi folks!
I've a 3d simulation with a heat source. I am using the k-omega model and coupled implicid solver. After a few thousand of iterations, the residuals are not changing any more. The only problem is that the energy residual is on a very high level (about 10^8). The solution seems to be convergent, but the temperatures are not correct... More iterations does not help... What is the problem?? Ralf |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Boundary layer in a pipe | Clementhuon | OpenFOAM Meshing & Mesh Conversion | 6 | March 12, 2012 12:41 |
[snappyHexMesh] snappyHexMesh - Refinement Level | andrea.pasquali | OpenFOAM Meshing & Mesh Conversion | 5 | February 8, 2010 03:08 |
High level researcher, Please read this mail(MHD) | YONG, JK | FLUENT | 0 | October 9, 2008 04:51 |
Problem on high density ratio in Level Set method | Kai Yan | Main CFD Forum | 10 | December 25, 2007 06:12 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |