New version fluent file open in Old version ?

October 29, 2005, 04:29

Hi i am asking that if there is any option than the file in making in Fluent 6.2 is open in 6.1.18

flow_CH · July 10, 2013, 05:12

yes. i have this question. How can i open fluent 14 .cas file into fluent 12?

blackmask · July 10, 2013, 05:43

I have a vague impression that it is not supported.

If you want to make a case in v12 with the same settings as v14, you can check whether fluent 12 support the TUI command

Code:

/file/read-settings

If so, you can read the v14 case file and save the settings via

Code:

/file/write-settings some-yes-or-no-or-file-name-i-really-do-not-remember

Then start fluent v12, read the mesh file and use

Code:

/file/read-settings file-name-of-your-v14-settings

to read the settings.

October 29, 2005, 04:29	New version fluent file open in Old version ?	#1
MANOJKUMAR Guest Posts: n/a	Hi i am asking that if there is any option than the file in making in Fluent 6.2 is open in 6.1.18

July 10, 2013, 05:43		#3
blackmask Senior Member Join Date: Aug 2011 Posts: 421 Blog Entries: 1 Rep Power: 23	I have a vague impression that it is not supported. If you want to make a case in v12 with the same settings as v14, you can check whether fluent 12 support the TUI command Code: /file/read-settings If so, you can read the v14 case file and save the settings via Code: /file/write-settings some-yes-or-no-or-file-name-i-really-do-not-remember Then start fluent v12, read the mesh file and use Code: /file/read-settings file-name-of-your-v14-settings to read the settings.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
2.0.x on Mac OSX	niklas	OpenFOAM Installation	74	March 28, 2012 17:46
[blockMesh] BlockMesh FOAM warning	gaottino	OpenFOAM Meshing & Mesh Conversion	7	July 19, 2010 15:11
OF 1.6 \| Ubuntu 9.10 (64bit) \| GLIBCXX_3.4.11 not found	piprus	OpenFOAM Installation	22	February 25, 2010 14:43
[Gmsh] Compiling gmshFoam with OpenFOAM-1.5	BlGene	OpenFOAM Meshing & Mesh Conversion	10	August 6, 2009 05:26
ParaView Compilation	jakaranda	OpenFOAM Installation	3	October 27, 2008 12:46

July 10, 2013, 05:12		#2
flow_CH Senior Member FHydro Join Date: Jan 2013 Posts: 197 Rep Power: 15	yes. i have this question. How can i open fluent 14 .cas file into fluent 12?