Home > Forums > Software User Forums > ANSYS > FLUENT

Modeling and meshing wheels' contact patches

Mark Forums Read

Reply

Search this Thread

December 23, 2005, 07:32	Modeling and meshing wheels' contact patches	#1
Modeling and meshing wheels' contact patches Guest Posts: n/a	Hi all! I am trying to simulate 3D flow over a car. The problem is that the elements surrounding the contact patch between ground and wheel have a high skewness because they are very flat due to the inherent geometry of this contact patch. Is there any "meshing cheat" to solve this issue? I've tried to reduce the lenght side of the tetrahedrons to 1mm, but skewness is still about 0.999 in those elements. Thanks a lot! (I'm meshing with Gambit)

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] CastNet: modeling and meshing tool for OpenFOAM	ulli	OpenFOAM Meshing & Mesh Conversion	7	May 31, 2011 01:14
Spiral pipe modeling and meshing	Adi	FLUENT	0	August 1, 2008 00:39
modeling and meshing of stator rotor	paras	CFX	0	June 6, 2005 07:12

All times are GMT -4. The time now is 22:22.