|
[Sponsors] |
January 24, 2006, 23:52 |
in need for an urgent answer
|
#1 |
Guest
Posts: n/a
|
Here is my issue I have created a wind tunnel with spires in it using Gambit and meshed it. I have imported that into Fluent, I want to know how can see the bounday layer or some sort of a plot between Bounday layer and position or atleast anything related to the Boundary layer. I will be very much grateful if some one could help me in some way . Thanks Neelima
|
|
January 25, 2006, 07:26 |
Re: in need for an urgent answer
|
#2 |
Guest
Posts: n/a
|
Although I have not properly understood your issue. But probably you have to make surface or line near the wall and plot the velocity vs grid-x (or grid-y)on that line or surface to get information about the boundary layer.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Jet fan and Tunnel simulation | ahlo7 | CFX | 9 | November 13, 2019 04:54 |
Simulation of Axial Fan Flow using A Momentum Source Subdomain | Liam | CFX | 28 | July 16, 2013 08:24 |
Momentum Source for fan | TX_Air | CFX | 5 | September 29, 2010 18:42 |
Propeller Fan Curve Simulation | Teng_YJ | FLUENT | 2 | February 16, 2009 19:37 |
urgent pressure condition for axial flow fan | VIPUL | FLUENT | 0 | October 24, 2008 02:01 |