|
[Sponsors] |
|
February 24, 2006, 08:13 |
Temperature limit 1.00 k in cell
|
#1 |
Guest
Posts: n/a
|
Hello, I doing injection and air temp is 650K and fuel is 303K and iterate then this above problem occur.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Solution technique/ Mesh type/ Cell limit/ Multi-zone regions in CFX | zandi | CFX | 5 | April 10, 2009 01:06 |
Finding the node temperature (not cell) | Parsa Zamankhan | FLUENT | 4 | August 22, 2007 15:38 |
How do I set lower temperature boundary limit? | Arefin Anwar | CFX | 1 | December 4, 2006 09:48 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
drastic increase of temperature in one cell | ravi | FLUENT | 7 | August 30, 2004 22:58 |