|
[Sponsors] |
February 25, 2006, 05:19 |
How to implement free surface bc indirectly
|
#1 |
Guest
Posts: n/a
|
Hi all, can somebody please tell me how to implement free surface boundary condition indirectly, using UDF (like DEFINE_PROFILE) in FLUENT? We can specify this bc directly by giving zero values to X and Y component of shear stress. But I want to know how to do this using UDF! Thanks & Regards Vishal
|
|
February 25, 2006, 21:22 |
Re: How to implement free surface bc indirectly
|
#2 |
Guest
Posts: n/a
|
Dear Vishal, I am not so sure but there exists a UDF in FLUENT UDFS list where you can compile and play safe. It is few lines of code and requires careful reading as it is well commented. Personally I hae no ideas nor I have used but it may help you. Let me know if that helps. also you can look in vivek ranades book there als he discusses few mwthods to implement free BC in FLUENT. Good Luck ! KP
|
|
February 26, 2006, 23:32 |
Re: How to implement free surface bc indirectly
|
#3 |
Guest
Posts: n/a
|
Hi KP, Thanks for the help. I found out how to specify the shear stress using UDF. Program is as follows, /* Free surface boundary condition using UDF */ #include "udf.h" DEFINE_PROFILE(freesur_profile, t, i) {
face_t f; begin_f_loop(f,t) { F_PROFILE(f,t,i) =0; } end_f_loop(f,t) } Thank you, once again. Vishal |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Thermocapillary free surface flow | zakifoam | OpenFOAM Running, Solving & CFD | 10 | December 12, 2016 11:44 |
Free surface is below than expected..results are not good | mechovator | CFX | 24 | April 8, 2011 00:41 |
Submarine Free Surface | samwh | CFX | 7 | August 30, 2009 07:14 |
Multiphase flow. Dispersed and free surface model | Luis | CFX | 8 | May 29, 2007 18:13 |
Modeling Free Surface Flows | Elliot Schwartz | Main CFD Forum | 5 | August 25, 1998 21:03 |