|
[Sponsors] |
March 23, 2006, 19:54 |
How to change levels of display
|
#1 |
Guest
Posts: n/a
|
Hello everyone, I have a problem...I am modelling open channel flow with air, water and a more dense underlying saline layer with a density difference of 22 kg/m3 between the water and the saline water, and need to know how to change the the levels to display the contors of the mixing of the fluids. As the desity of the air and water differ by so much, Fluent will not display the density difference of the saline to water as it is so small in comparison. Does anyone have any ideas on how to overcome this problem? Thanks for your time. Natalie
|
|
March 23, 2006, 21:34 |
Re: How to change levels of display
|
#2 |
Guest
Posts: n/a
|
I worked it out, so please ignore this message.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Solid/liquid phase change | fabian_roesler | OpenFOAM | 10 | December 24, 2012 06:37 |
Change cell zone index/thread during simulation | neilduffy1024 | FLUENT | 0 | January 17, 2011 09:40 |
no enthalpy change across the momentum source | Atit Koonsrisuk | CFX | 2 | December 19, 2005 02:33 |
free surface display | carno | Siemens | 4 | October 7, 2005 01:03 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |