|
[Sponsors] |
April 7, 2006, 07:43 |
Virtual Wind Tunnel in FLUENT
|
#1 |
Guest
Posts: n/a
|
Hi everyone, I am trying to simultae a fan driven wind tunnal in a room through Fluent. Problem is that when I run the simulation, I can see the velocity/pressure etc variations within the wind tunnel but there is almost no effect around the inlet and outlet of the wind tunnel...Any Idea? I have tried Pressure inlet, Mass flow inlet , pressure outlet, outflow etc in different combinations for inlet and outlet conditions. Fan is inside the wind tunnel (a face). I have two seperate interior fluid domains of room (excluding wind tunnel) and wind tunnel itself. Tne inlet and outlet of wind tunnel is with a common face to outer domain (room) and inner domain (windtunnel). Thanks in anticipation...
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Developing velocity profile in virtual wind tunnel | Nicki Parker | CFX | 2 | January 11, 2008 05:02 |
Simulating a Göttingen type wind tunnel in FLUENT | Chris | FLUENT | 3 | December 4, 2006 17:33 |
Comparing wind tunnel tests costs with CFD | Freeman | Main CFD Forum | 9 | January 30, 2006 08:02 |
CFD v.s wind tunnel in airfoil | FRED CHEN | CFX | 0 | July 12, 2005 02:59 |
wind tunnel correction | Arthur Chen | Main CFD Forum | 2 | September 4, 1998 18:42 |