|
[Sponsors] |
April 25, 2006, 13:13 |
bluff body and Y+
|
#1 |
Guest
Posts: n/a
|
Hi,everyone. I am studying wind environment around buildings. The problem is how to easily set the first cells aroud the bluff body to make the y+ at the desirable range (30~60). As the pressure and stress on the surfaces are variable, that means the first cells should be different. Now I used the structured mesh. After convergence, the range of y+ on the suface was from 40 ~ 1000. If I use y+ grid adaption, the range of y+ droped down slowly ( once about half decrease)and every convergence spend a long time.
Do you have any strategies or suggestions? Thanks in advance Justin |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bluff body used for diffuser testing | lemat1 | Siemens | 0 | December 5, 2009 09:11 |
temperature going negative behind a bluff body | Sourabh | Phoenics | 6 | December 1, 2007 18:50 |
Bluff Body | krithiga | Siemens | 4 | November 7, 2006 15:45 |
UDF for lift force on a bluff body | sawa | FLUENT | 2 | April 11, 2005 03:06 |
triangular bluff body | Pratap | Main CFD Forum | 0 | April 5, 2004 02:23 |