|
[Sponsors] |
June 3, 2006, 06:44 |
about the massflow rate boundary condition
|
#1 |
Guest
Posts: n/a
|
i want to simulate the exhaust system of engine,i have got the massflow vs crank angle,but i can't input massflow rate on the inlet boundary,must i change the massflow rate into mass flux?
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
vorticity boundary condition | bearcharge | Main CFD Forum | 0 | May 14, 2010 12:32 |
CFX Solver : Sudden crash | Hervé | CFX | 2 | June 16, 2008 07:40 |
Slip boundary condition what is inside | normunds | OpenFOAM Running, Solving & CFD | 2 | June 4, 2007 07:45 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 05:15 |
massflow outlet boundary condition ?? | Charles Renard | Main CFD Forum | 6 | August 20, 2001 04:27 |