|
[Sponsors] |
June 23, 2006, 11:21 |
What Damkohler number
|
#1 |
Guest
Posts: n/a
|
Hello Friend,
what is Damkohler number and how can i find it ,.... is it very essential to determine it to decide which model to use for combustion simulation,... How to decide which model to use, using this number Regards ,.. Rams |
|
June 23, 2006, 12:24 |
Re: What Damkohler number
|
#2 |
Guest
Posts: n/a
|
This number is a number which gives u a comparison of tubulent time scales and chemical time scales .... when turbulent time time become ver small it ... it is the turbulence which starts interacting with chwmistry .... may be combustion ..... in Fluent u have extremely slow ...(computationally expensive model) EDC .... eddy dissipation concept which takes turbulence into account apart from LES and DES simulations which are extremely computationally expensive. u can use this ...
|
|
June 24, 2006, 04:29 |
Re: What Damkohler number
|
#3 |
Guest
Posts: n/a
|
I have solved a combustion problem using mixture fraction Pdf model without checking for damkohler number,...
Am having a problem with the solution,.. am getting negative pressures at nozzle throats,... is this bcoz i may have selected wrong model,.. i have even tried to solve the same problem with species transport model but i failed even to start the solution with that model,..... what should i do,.. to get correct result,... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[mesh manipulation] Mesh Refinement | Luiz Eduardo Bittencourt Sampaio (Sampaio) | OpenFOAM Meshing & Mesh Conversion | 42 | January 8, 2017 12:55 |
DecomposePar unequal number of shared faces | maka | OpenFOAM Pre-Processing | 6 | August 12, 2010 09:01 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
Unaligned accesses on IA64 | andre | OpenFOAM | 5 | June 23, 2008 10:37 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |