DEFINE_DPM_INJECTION_INIT

jfg39

Hi there,

I would like to write a UDF that injects particles near the wall of a cylinder. I want to use DEFINE_DPM_INJECTION_INIT but I don't understand in the UDF manual how it works (especially what is the line that inject the particle).

In fact, I would like to loop over the cells of a face, and then inject a particle in the centre of the convenient cells (those who are on the border of the inlet face of the cylinder).

Could you give me advice ?

PS: I'm French, so I do apologize on my bad English ... Confused