Home > Forums > Software User Forums > ANSYS > FLUENT

node values or cell values?

Mark Forums Read

Reply

Search this Thread

November 10, 2006, 09:56	node values or cell values?	#1
aPpA Guest Posts: n/a	Can any one tell me if i should use node values or cell values to plot the gas holdup in a two phase pipe flow simulation? The cell values dont give me a smooth curve. Which values should i consider to validate the data with experiments? Thanks in advance

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Cells with t below lower limit	Purushothama	Siemens	2	May 31, 2010 22:58
Store Array elements in cell values	Leverkin	FLUENT	0	February 3, 2009 05:36
How to obtain node values in UDF?	Maciej	FLUENT	0	October 23, 2006 09:10
fixing cell values	Saurav	FLUENT	3	September 21, 2005 09:30
Warning 097-	AB	Siemens	6	November 15, 2004 05:41

All times are GMT -4. The time now is 15:27.