|
[Sponsors] |
June 4, 2007, 07:42 |
interpolate error of boundary profile
|
#1 |
Guest
Posts: n/a
|
Hello eveyone,
I am using experiment data of atmospheric boundary layer to write inlet boudary profile by point style. the results show that velocity profile along the inlet is not same, but the tke profile is very well. The maximum error of velocity profile is about 10%. is its due to interpolate? How can I reduce this error as the experiment data is not enough? Any suggestion? Best regards Justin |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Heat Flux as a Profile Boundary Condition | Hitch8 | CFX | 2 | April 22, 2010 13:09 |
Using a boundary profile file with unsteady, spatially varying data | jonnythewlis | FLUENT | 0 | December 8, 2009 15:49 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Boundary profile for multiple time steps | Matt | FLUENT | 0 | April 13, 2006 14:59 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |