Question: parameters copy

June 26, 2007, 11:28

Hi, guys

A model consists of two parts (two zones). I got some results in a part (zone 1). How do I copy these results to the other part (zone 2)? The two zones have same dimensions and mesh structures. My idea is to copy data in zone 1 to corresponding cells in zone 2. Could you give me a brief UDF code? I appreciate it.

Cheer, Braket

June 27, 2007, 08:30

Im not sure if it'll work for your case but you could write an interpolation file for zone 1 then read it into zone 2 so as to avoid using a UDF

June 26, 2007, 11:28	Question: parameters copy	#1
braket Guest Posts: n/a	Hi, guys A model consists of two parts (two zones). I got some results in a part (zone 1). How do I copy these results to the other part (zone 2)? The two zones have same dimensions and mesh structures. My idea is to copy data in zone 1 to corresponding cells in zone 2. Could you give me a brief UDF code? I appreciate it. Cheer, Braket

June 27, 2007, 08:30	Re: Question: parameters copy	#2
Neil Guest Posts: n/a	Im not sure if it'll work for your case but you could write an interpolation file for zone 1 then read it into zone 2 so as to avoid using a UDF

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
question about uds	tanven	FLUENT	2	July 5, 2015 11:22
Unanswered question	niklas	OpenFOAM	2	July 31, 2013 16:03
CFD output question	Moonlighter	Main CFD Forum	2	December 21, 2009 14:29
Is it OK to copy Wikipedia article to CFD-wiki?	CFDer	CFD-Wiki	4	December 11, 2009 06:16
Poisson Solver question	Suresh	Main CFD Forum	3	August 12, 2005 04:37