|
[Sponsors] |
July 3, 2007, 10:43 |
Trouble with Tgrid Prisms
|
#1 |
Guest
Posts: n/a
|
Hi,
I'm trying to grow a prism layer around a propeller in Tgrid. If I try to grow it over the blade, hub, and shaft it gives me a 'prism growth halted due to quality' error. If I limit it to the blade, then it grows; however, when I try to create a new domain so that I can tet mesh everything else, the auto-meshing fails telling me that there are 'no cell zones.' Hopefully this is just a stupid error on my part but has anyone had any experience with this? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Cannot convert fluent or tgrid hexcore mesh | aerogt3 | OpenFOAM Meshing & Mesh Conversion | 2 | October 22, 2010 11:55 |
[TGrid] Tgrid hybrid mesh pyramid transition | tony00 | ANSYS Meshing & Geometry | 4 | November 26, 2009 04:36 |
CFX Pre - TGrid | Vivek Vasudevan | CFX | 2 | March 20, 2007 06:31 |
TGrid: segmentation violation error | Vincent | FLUENT | 0 | February 15, 2006 10:34 |
to tgrid or not to tgrid | Nurul Murad | FLUENT | 1 | July 6, 2001 13:21 |