|
[Sponsors] |
July 20, 2007, 09:58 |
divergence detected
|
#1 |
Guest
Posts: n/a
|
I am working in a compressor stage, I am trying to validate the model with results of other software CFX, so replicated the whole model in terms of the geometry and boundary conditions as well initial conditions, though after a few iterations the simulations stops with the following error message "Error: divergence detected in AMG solver: temperature" I check everything over and over but seems that the problem is not there, though I noticed temperature and pressure limited in the volumes of my model. So I wonder if anyone could help me out on this in order to figure it out.
Thanks in advance. German |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Divergence detected in AMG solver: ads-0 | Patrino | FLUENT | 6 | May 12, 2022 03:11 |
Quarter Burner mesh with periosic condition | SamCanuck | FLUENT | 2 | August 31, 2011 11:34 |
Divergence detected when using parallel solver | Phil | FLUENT | 3 | May 9, 2008 08:17 |
user subroutine error | CFDUSER | CFX | 2 | December 9, 2006 06:31 |
user defined function | cfduser | CFX | 0 | April 29, 2006 10:58 |