|
[Sponsors] |
August 22, 2007, 15:16 |
Porous jump
|
#1 |
Guest
Posts: n/a
|
I m trying mold filling using VOF model so i m trying to give porous boundary condition on the top face. but it is showing some error. is it possible to give porous boundry condition on a particular face rather than a particular volume?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] How can I define different zones in ICEM? | llrr | ANSYS Meshing & Geometry | 14 | February 12, 2017 13:44 |
[Commercial meshers] Porous Jump creation problem | mulfal | OpenFOAM Meshing & Mesh Conversion | 4 | December 9, 2013 11:59 |
Porous jump in urban environment | samygero | FLUENT | 0 | February 14, 2011 18:26 |
Porous Jump | Naresh | FLUENT | 0 | April 25, 2007 15:36 |
Testing the integrity of POROUS media and por jump | Azman | FLUENT | 0 | July 31, 2006 11:11 |