|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hi I have enquiry in drawing the grid for a 3D pipe with boundary layer. I want know how i can divide the boundary layer into nodes for each section of pipe in which there is a node every 2 degree? How know this pls need urgent help?
Thanks to any help kb |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
please give the software information for my project work
|
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
I am work with Gambit version 2.2.3 what your project work.
|
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
what is the my relation of my question with your project work?
kb |
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[DesignModeler] DesignModeler Pipe within pipe | shields | ANSYS Meshing & Geometry | 13 | November 25, 2018 23:14 |
How to mesh 3 D pipe sections with limited nodes | kbs | FLUENT | 3 | September 5, 2007 09:47 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 10:11 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 13, 2001 00:19 |
fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 22:31 |