|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
I am a beginner of the Fluent. Now I am using Fluent to simulate a water injection in a high speed unsteady flow field. I meet a huge problem. When the interaction option was turned on, the temperature and velocity goes to unbelievable values. Some reach the limit values.
I check the grid, which is fine for the high speed flow. But the DPM model asks for the coarser grid. How can I set the case correctly when the Fluent is used to my simulation? Can anyone help me? Thanks a lot! |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to couple VOF and DPM ?? | cfdiscool | FLUENT | 7 | July 18, 2024 03:02 |
DPM Modeling of high Biot Number Particles | Bob Stanislawsky | FLUENT | 1 | June 7, 2017 02:15 |
dpm spray into open air | kev | FLUENT | 1 | December 3, 2005 02:52 |