I need to use the outputs of two seperate models as inputs in a third model (mixing zone), is that possbile to do?

Hello Mido,

Perhaps using a boundary profile.

Write profile (velocity, turbulence quantities, temperature, etc..) for each model output. Be carefull with mesh resolution and boundary profile location.

Then read each profile into the new model, and the code interpolate this results into the new mesh.

use interpolate values as the boundary conditions for your third model.

good luck!

Thanks pulgarcito, I was able to save my gas oulet profile and my liquid outlet profile seperatly, but i didnt know how to upload them onto the the two inlets in my mixing model. Could you guide me through, Thanks for your help