|
[Sponsors] |
April 8, 2008, 12:31 |
Rubber Compression Moulding
|
#1 |
Guest
Posts: n/a
|
Hi Guys,
I need to make a finite element analysis for a rubber compression mold through Abaqus -I was trying but failed-,I dont really understand, how could I do it, let give you a little summary, of it. Process A pre-weighed, generally preformed piece of material / compound is placed in the mould : the mould is closed, with the sample under pressure as it vulcanizes Cavity pressure is maintained by slightly over filling the mould & holding it closed in a hydraulic press. Constant heat is provided by electric heatess, thermic fluid or steam Best Regards. Pablo Ulloa |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
compression of oil | CFD user | Siemens | 0 | February 24, 2006 04:46 |
RUBBER EXTRUSION SIMULATION | RICAROD OTERO | Main CFD Forum | 3 | July 30, 2004 03:49 |
injection moulding simulation | Oscar | Main CFD Forum | 3 | April 28, 2003 20:39 |
Gas compression | andreis | CFX | 4 | August 1, 2002 10:48 |
cold runner deck for injection rubber | Bernard Gullett | Main CFD Forum | 0 | November 23, 1998 22:40 |