|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
I´m looking for softwares in order to simulate the injection moulding process.
I´m also trying to simulate the in-mould decoration process (specially with textile), and I´m having difuculties in simulating the asymetric flow that occurs in both parts of the mold (steel-wall and textile-wall). Thanks for your answers. |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
You might check Flow Science, Santa Fe, New Mexico. They publish, market, and support flow3d. Flow3d was developed for free surface flows and is widely used for injection molding and related casting problems.
http://www.flow3d.com I have no business interest in Flow Science Inc. |
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
Thanks, We have no any intereset in commertial software at here.
. |
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
Sorry, I just answered the question that Oscar asked.
|
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
GUI crash and simulation engine still running | RPJones | FLOW-3D | 2 | November 9, 2010 09:18 |
velocity profile export from a simulation onto another | sudhirlv | STAR-CCM+ | 1 | September 12, 2010 19:57 |
Injection definition | dokeun | FLUENT | 1 | July 19, 2010 10:07 |
Replacing mesh while running a simulation | akultane | CFX | 1 | November 15, 2009 14:46 |
simulation of gasoline direct injection | bilalalfaisal | FLUENT | 0 | October 20, 2009 04:55 |