|
[Sponsors] |
April 24, 2008, 12:27 |
Mesh point increment
|
#1 |
Guest
Posts: n/a
|
Hi, I'm trying to mesh different surfaces in a 3d geometry. I need to have very fine Tri-Pave mesh with 'interval size' of about 0.02. But for large surfaces, I don't get them meshed because required points exceed 100000. Can anyone tell me how to increase this limit to have more number of points and get the surface meshed completely?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh Point is not inside Mesh but it is | wolle1982 | OpenFOAM Meshing & Mesh Conversion | 14 | March 25, 2024 05:46 |
[Other] How to mesh the 1st grid point | lakeat | OpenFOAM Meshing & Mesh Conversion | 1 | October 8, 2007 07:13 |
How to mesh the 1st grid point? | Daniel | Main CFD Forum | 1 | October 8, 2007 02:27 |
increment in volume fraction after 200 time steps | Rashmi | FLUENT | 3 | May 22, 2006 00:22 |
What's the point of imprting an stl mesh? | philip | FLUENT | 8 | July 6, 2005 16:51 |