|
[Sponsors] |
April 30, 2008, 12:41 |
Meshing a small section in GAMBIT
|
#1 |
Guest
Posts: n/a
|
I am modeling a 8 degrees section of a system. I have a hard time getting a nice mesh, and it seems that I can only use the tri/hex mesh option. I end up having very skewed meshes in the volumes close to the axis and FLUENT ends up diverging after a few iterations. Anybody has ever had to model such a wedge with small angles
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
small Gambit menu problem | Subhash C. Bose | FLUENT | 5 | July 18, 2010 06:20 |
meshing very small tubes | Wooster | CFX | 6 | July 23, 2007 10:41 |
Gambit: mesh size to small??? | Ralf Schmidt | FLUENT | 1 | January 28, 2006 01:26 |
Meshing a domain with very small slit using Gambit | Rucy | FLUENT | 0 | November 14, 2005 02:29 |
Problems meshing a pie-shape cross-section bar-suggestions or workarounds needed | Ricky Wong | FLUENT | 1 | May 11, 2000 17:35 |