|
[Sponsors] |
May 20, 2008, 09:07 |
Help for Adaption required!
|
#1 |
Guest
Posts: n/a
|
I built a very coarse mesh in Gambit and want to refine it with the adaption panel in Fluent now. My Problem is, that fluent marks my desired cells, but the refining is only performed in radial direction and not in axial. So the cells have still a length of several cm's and a height of a few mm's now. How can i solve this problem??
Thanks! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
adaption | Muhammad Qureshi | FLUENT | 0 | December 22, 2008 05:14 |
y+ adaption | AAA | FLUENT | 2 | July 24, 2007 19:21 |
Y+ adaption | Marc | FLUENT | 1 | December 19, 2005 11:05 |
boundary adaption with geometry based adaption | Kate | FLUENT | 0 | October 9, 2005 10:44 |
Adaption.. | Joe | CFX | 3 | March 30, 2005 18:27 |