|
[Sponsors] |
August 1, 2008, 09:37 |
Divergence problem - NOT the mesh
|
#1 |
Guest
Posts: n/a
|
Hi,
I am running my 60th vehicle aerodynamics simulation now on my 6oth different mesh but there are major problems. The solution is converging ok for 35 iterations and then it blows up with divergence detected in the solver. My mesh is of high quality so this is not the problem. I cannot see how lowering the URF's will help, any ideas what might be causing this? I REALLY don't wanna re-mesh to find the same problem again. Any help would be much appreciated. Cheers, Carlos. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
About the divergence when using unstructured mesh | Shamoon | FLUENT | 2 | June 22, 2008 09:00 |
About the divergence when using unstructured mesh | SHAMOON | FLUENT | 4 | June 20, 2008 13:17 |
divergence of moving mesh | ricklee | Siemens | 2 | June 27, 2005 03:53 |
Divergence in Dynamic Mesh Problem | James | FLUENT | 0 | September 28, 2004 08:43 |
divergence problem.. | jieremy | FLUENT | 8 | May 23, 2003 03:17 |