September 26, 2008, 11:42
|
Error meshing a helicopter rotor with Gambit
|
#1
|
Guest
|
Hello! I need help for a problem with Gambit. I am modelling a Helicopter rotor. I do it with solidworks and I put the rotor into a greater cylinder to simulate the fluid motion. I imported it in .igs on gambit, i did surface mesh and it's ok. When I try to mesh the volume between cylinder and rotor (obtained with boolean subtraction...), Gambit gives me the following errors: " Initialization failed ERROR: TG_Mesh domain failed with error code 1. ERROR: Tetrahedral meshing has failed for volume2. This is usually caused by problems in the face meshes. Check the skewnesses of your face meshes and make sur the face meshes sizes are not too large in areas of small gaps." I try to change mesh type and size, to smooth geometry and to clean up bad geometry also but I have the same result. Thank you for your help.
|
|
|