|
[Sponsors] |
setting boundary conditions on internal edges |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 6, 2008, 08:16 |
setting boundary conditions on internal edges
|
#1 |
Guest
Posts: n/a
|
Hi there,
Wondering if I could get some suggestions on my model. I have created a 2d face with three internal edges that extend vertically down from the outer edge of the face but do not reconnect with the lower edge of the face (ie there are gaps so that the flow can go through). Whenever I try to set a boundary condition on these internal edges eg interior and then export the mesh (selecting the 2D option) I get the message WARN: Boundary entity X does not contain any valid entity and is not written. Also, to see if the problem goes away I have graded and meshed the three internal edges. If I don't set any boundary conditions on these edges they don't appear to show up when I look at the grid in Fluent. Is there something else I should also be considering? Thanks for your help. Cheers Renate |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
boundary conditions for internal faces | Tom Pendrey | FLUENT | 1 | March 5, 2007 18:25 |
Setting a boundary conditions | mer | OpenFOAM Running, Solving & CFD | 1 | November 24, 2005 13:53 |
Boundary Conditions for internal surface | Giordano Bruno | FLUENT | 0 | January 9, 2005 12:51 |
Boundary conditions for internal flow | lavan | Main CFD Forum | 2 | November 4, 2004 13:36 |
'internal' and 'interior' boundary conditions | Vishu | FLUENT | 0 | January 28, 2004 21:25 |