|
[Sponsors] |
December 9, 2008, 09:04 |
Interface problem
|
#1 |
Guest
Posts: n/a
|
There are 2 volume which are connected by one common sharing interface (face). The mesh around this single interface is non-conformal. During the computation, the turbulent viscosity reaches to its limit and then after some iteration the fluent stops. The problem causes no out flow from pressure outlet and the velocity remains zero at this face and everywhere. The cells with high turbulent visosity are located around the interface.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Interface problem | gopi | FLUENT | 0 | August 30, 2007 02:46 |
Interface problem | sai | FLUENT | 1 | January 19, 2007 02:26 |
Interface problem | Tomislav | FLUENT | 4 | May 23, 2006 00:49 |
GGI interface problem (CFX-5.7.1) | Jesper | CFX | 3 | May 14, 2005 18:06 |
CAD Interface problem | sweenam | Phoenics | 0 | November 9, 2002 06:08 |