Home > Forums > Software User Forums > ANSYS > FLUENT

Turbulent Flow in a Square Duct using LES

Mark Forums Read

Reply

Search this Thread

February 7, 2009, 21:25	Turbulent Flow in a Square Duct using LES	#1
Hock Ming Guest Posts: n/a	Hi, I'm using LES solver to simulate a transient turbulent flow in a square duct using pressure gradient. However, after more than 200,000 time steps(time step size of 0.0001), I still can't get any mean secondary flow at the corner region of the duct. Has anybody done the same simulation and achieve the desired mean secondary flow?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with secondary flow in a square duct	cfdmarkus	OpenFOAM Running, Solving & CFD	19	May 10, 2012 11:50
Turbulent flow in a rectangular duct foam vs fluent	atzaru	OpenFOAM Pre-Processing	7	February 13, 2007 15:42
problem about square duct.	Bin Li	Main CFD Forum	0	December 29, 2003 23:11
help! flow in square duct	chris	Main CFD Forum	2	December 22, 2003 11:13

All times are GMT -4. The time now is 23:28.