|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
FlowRider
Join Date: Apr 2009
Posts: 2
Rep Power: 0 ![]() |
Hi all
I was wondering if someone could give me advice or point me in the right direction in terms of choosing the correct constants when using the std k-epsilon model. I am currently simulating flow over a symmetric airfoil and would like to investigate the turbulence experienced at various angles of attack. I believe these constants were derived for flows through a pipe and grid and is thus obviously very different to that of flow over an airfoil Any help would be appreciated FlowRider |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
k epsilon model constants for specific application | Flavio | Main CFD Forum | 0 | February 5, 2009 04:43 |
LES and combustion model | Margherita Cadorin | CFX | 0 | October 29, 2008 05:24 |
Redefining model constants in S-A turbulence | Amit | FLUENT | 0 | January 16, 2007 13:21 |
model | han | Main CFD Forum | 0 | September 27, 2005 08:35 |
Advanced Turbulence Modeling in Fluent, Realizable k-epsilon Model | Jonas Larsson | FLUENT | 5 | March 13, 2000 03:27 |