|
[Sponsors] |
July 23, 2009, 16:42 |
Very high or negative pressures
|
#1 |
Member
Join Date: Apr 2009
Posts: 94
Rep Power: 17 |
Dear All,
I am modeling a pipe with dynamic mesh. One end is a piston, the other end is an outlet/outflow. Case setup: k-epsilon incompressible: air density = 2.33 kg/m^3 = constant. Operating pressure = 265kPa at piston; also tried 0 Pa. I tried the open pipe end as outlet as well as outflow. The first step of the motion ends always with wrong static pressures. Next to piston they are very high (>1E+6). If the open end is an outflow, then the pressure there becomes negative. Please help me correct the errors in this case. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
Negative pressures in the flow domain | mahut | FLUENT | 2 | September 27, 2007 05:07 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
dynamic mesh, negative absolute pressures | Jason | FLUENT | 0 | March 15, 2005 09:36 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |