September 23, 2009, 09:19
|
Dynamic mesh + apaption in Fluent 12 ?
|
#1
|
New Member
David del Campo Sud
Join Date: Jul 2009
Posts: 2
Rep Power: 0
|
Hi!
I am modeling a gear pump in which mesh deformation is too big to keep a good quality along the whole cycle, so I decided to use an adapt command after each certain number of time steps. In Fluent 6.3 I used "conformal" adaption since "hanging" didn't seem to work with dynamic meshes (giving segmentation fault when trying to iterate after the adaption). But I had to pass to Fluent 12 and it seems that the "conformal" option has been eliminated from this new version, so I can just use "hanging", but it still doesn't support dynamic meshes... Am I right? Do you know a way to adapt dynamic meshes in Fluent 12?
Thanks very much in advance
|
|
|