|
[Sponsors] |
November 22, 2009, 10:40 |
controling loops on cells
|
#1 |
Member
MOHSEN Zendehbad
Join Date: Aug 2009
Posts: 35
Rep Power: 16 |
we can loop on all the cells of a thread by writing the following lines, but is there any way to control this loop, i mean can we make it start from a specific coordinate or specific cell or it should always start from a specific cell?
begin_c_loop(c0,t0) {} end_c_loop(c0,t0) |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Netgen] Import netgen mesh to OpenFOAM | hsieh | OpenFOAM Meshing & Mesh Conversion | 32 | September 13, 2011 05:50 |
physical boundary error!! | kris | Siemens | 2 | August 3, 2005 00:32 |
Ignore cells on partition boundary | Karl | FLUENT | 7 | May 11, 2002 22:12 |
Looping over cells | Karl | FLUENT | 4 | March 26, 2002 21:18 |
UDF: neighbour cells, upwind cells | Dmitriy Makarov | FLUENT | 0 | February 18, 2001 13:53 |